Description
The WB component “WB-MC” enables communicative networking with remote components among themselves. It also supports the exchange of information with third-party systems via standard protocols.
There are two typical areas of application:
1.) Communicative connection of a WITT Bridge measurement extension to a higher-level SCADA system.
2.) Connection of different WB components to monitor the cable infrastructure. Optionally, a WB-HS can monitor and configure everything centrally.
Product WB-MC Variant:
CANopen 1 channel 12mm
CANopen 2 channel 12mm
IEC 60870-5-103 / DIN EN 60870-5-103
IEC 60870-5-104 / DIN EN 60870-5-104
IEC 61850
ModBus/TCP
ModBus/RTU
PROFIBUS
other variants on request
Function
The WB-MC component is connected to the WB backplane bus with third WB components. The WB component “translates” information from the WB components connected to the backplane bus and the external protocol.
Depending on the protocol used and the WB components, a wide variety of quantities and information can be transmitted:
- operational status
- control commands
- real value
- target values
- event-based transmission
- no “real-time” transmissions
Technical specifications
Product WB-MC variant:
-
CANOpen 1 channel 12mm
-
CANOpen 2 channel 12mm
-
IEC 60870-5-103 / DIN EN 60870-5-103
-
IEC 60870-5-104 / DIN EN 60870-5-104
-
IEC 61850
-
ModBus/TCP
-
ModBus/RTU
-
PROFIBUS
-
other variants on request
each with galvanic isolation
Analog input channels (measuring channels)
NONE
Digital input channels
NONE
Output channels digital
NONE
Display
Possible variants depending on the range of functions or options
|
LED
|
color
|
Caption
|
Description
|
|
1
|
green
|
Run
|
Permanently ON: Operational
|
|
2
|
green
|
Run
|
Duration ON:
Flashes: Component boots and connects to the backplane BUS and external units
|
|
3
|
red
|
Error
|
Functional malfunction of the system or sensors or equipment
|
Parameterization
“Configuration profiles” are stored in the servicekoffer CM1010 / VLD1010 and transferred to the WB component.
Digital Values
The following digital values can be passed on by the components to third-party systems or queried by third parties.
Possibilities are also listed depending on the components, configuration, installed options and system structure as well as the protocol used.
values- output
- Product type including extension
- Serial number including the extension
- Article number
- Soft and hardware versions
- Type protocol and its configuration
values input
- Parameters for configuring the installed protocol
operational status
- Error with error code
- Run
- Standby
- Automatic
Command
- Perform self-test
- Reset System
- Reset switch counter
- Switch to standby mode
- Switch to automatic mode
